Photo AI
Question 1
A 215 mm solid concrete block wall separates two rooms on the ground floor of a dwelling house, as shown. A strip foundation supports the wall, which is plastered on... show full transcript
Step 1
Answer
Draw the Vertical Section: Begin by sketching the section through the wall, foundation, and floor at a scale of 1:5. Show the strip foundation beneath the wall, ensuring to depict the 215 mm solid concrete block wall rising above.
Include the Door Section: Represent the flush panel door positioned in the wall, maintaining the 60 mm thickness and the 120 mm × 50 mm doorframe.
Add the Ground Floor Details: Illustrate the insulated concrete floor, ensuring to represent the 20 mm tongue and groove floating hardwood floor.
Mark Dimensions: Clearly indicate the height of the wall, the width of the foundation, and the overall height to the finished floor level (500 mm above the finished floor). Include a total of three typical dimensions to comply with the requirements.
Step 2
Answer
Radon Barrier Layer: Illustrate a continuous layer of impervious material (e.g., polyethylene) placed underneath the floor to act as a radon barrier. Ensure this layer extends across the entire area under the concrete.
Seal Joints: Represent all joints in the gas barrier as tightly sealed using appropriate tape or sealant to prevent any gaps that could allow radon gas infiltration.
Drainage System: Optionally, indicate a drainage layer below the radon barrier that guides any accumulating water away from the foundation, preventing any potential degradation of the barrier from moisture.
Report Improved Results
Recommend to friends
Students Supported
Questions answered