Photo AI
5.1 Draw a neat freehand drawing in your ANSWER BOOK to show the installation of a gutter, down-pipe installation with an offset pipe and rain-water shoe as seen from the side - NSC Civil Technology Civil Services - Question 5 - 2021 - Paper 1
Question 5
5.1 Draw a neat freehand drawing in your ANSWER BOOK to show the installation of a gutter, down-pipe installation with an offset pipe and rain-water shoe as seen fro... show full transcript
Worked Solution & Example Answer:5.1 Draw a neat freehand drawing in your ANSWER BOOK to show the installation of a gutter, down-pipe installation with an offset pipe and rain-water shoe as seen from the side - NSC Civil Technology Civil Services - Question 5 - 2021 - Paper 1
Step 1
5.1 Draw a neat freehand drawing in your ANSWER BOOK to show the installation of a gutter, down-pipe installation with an offset pipe and rain-water shoe as seen from the side.
Answer
To fulfill this request, sketch a detailed and clear freehand drawing showing the installation of a gutter and down-pipe system. Ensure you depict the offset pipe and the rain-water shoe accurately. Use dimensions where necessary to enhance clarity.
Step 2
5.2 FIGURE 5.2 below shows drawings of a concrete shoe and a surface channel. Explain the purpose of each.
Answer
The concrete shoe is designed to channel water away from the house or building. This is crucial for preventing water accumulation around the foundation, which can lead to structural damage.
Conversely, the surface channel is intended to direct water flow towards rivers or drainage systems. It effectively manages surface runoff, reducing the risk of flooding and erosion.
Step 3
Step 4
5.4 Use the drawing and the information on ANSWER SHEET 5.4 and draw OEN development of the vertical cylindrical pipe elbow. Start the development at A, showing the 3 mm seam on both sides.
Answer
Begin by transferring the dimensions from the front and top views of the cylindrical pipe elbow onto your answer sheet. Mark the development at point A, ensuring to include a 3 mm seam on both sides. Then, create the unrolled version of the elbow, maintaining the correct measurements and angles. Make sure to use construction lines to guide your drawing without redrawing the figure itself.