6.1
Label the MIG-welding equipment indicated in FIGURE 6.1 according to the letters A–I - NSC Mechanical Technology Automotive - Question 6 - 2017 - Paper 1
Question 6
6.1
Label the MIG-welding equipment indicated in FIGURE 6.1 according to the letters A–I.
6.2
Label the MIG-welding process indicated in FIGURE 6.2 according to the... show full transcript
Worked Solution & Example Answer:6.1
Label the MIG-welding equipment indicated in FIGURE 6.1 according to the letters A–I - NSC Mechanical Technology Automotive - Question 6 - 2017 - Paper 1
Step 1
Label the MIG-welding equipment indicated in FIGURE 6.1 according to the letters A–I.
96%
114 rated
Only available for registered users.
Sign up now to view full answer, or log in if you already have an account!
Answer
A. Regulator
B. Flow meter
C. Continuous wire reel
D. Wire feed roller unit
E. Gun conduit
F. Welding gun
G. Weld pool
H. Workpiece
I. Earth clamp
Step 2
Label the MIG-welding process indicated in FIGURE 6.2 according to the letters A–E.
99%
104 rated
Only available for registered users.
Sign up now to view full answer, or log in if you already have an account!
Answer
A. Parent metal
B. Molten pool
C. Continuous electrode wire
D. Nozzle
E. Gas shroud
Step 3
Name THREE non-destructive tests that can be performed on welded joints.
96%
101 rated
Only available for registered users.
Sign up now to view full answer, or log in if you already have an account!
Answer
X-ray testing
Liquid dye penetrant testing
Ultrasonic testing
Step 4
Explain how the nick-break test is performed on a weld.
98%
120 rated
Only available for registered users.
Sign up now to view full answer, or log in if you already have an account!
Answer
To perform the nick-break test, firstly make a hacksaw cut at both edges through the center of the weld. Next, use a sledge hammer to break the specimen by striking it in the zone where the saw cuts were made. Finally, ensure that the weld metal exposed in the break should be completely free from slag inclusions and contain no gas pockets greater than 1.6 mm.
Step 5
What is the purpose of inert gas with the MIG-welding process?
97%
117 rated
Only available for registered users.
Sign up now to view full answer, or log in if you already have an account!
Answer
The purpose of inert gas in the MIG-welding process is to protect the weld area from oxygen and water vapor, which can cause defects in the weld.
Step 6
After inspecting a weld, slag inclusion was discovered in the weld. Name TWO causes for this.
97%
121 rated
Only available for registered users.
Sign up now to view full answer, or log in if you already have an account!
Answer
Solid metals entrapped in the weld metal or between the weld metal and the base metal.
Insufficient weld temperature, leading to improper melting.
