2.1 Explain TWO first-aid measures to consider when treating an open wound - NSC Mechanical Technology Fitting and Machining - Question 2 - 2021 - Paper 1
Question 2
2.1 Explain TWO first-aid measures to consider when treating an open wound.
2.2 State TWO safety precautions that must be adhered to after the surface grinder has b... show full transcript
Worked Solution & Example Answer:2.1 Explain TWO first-aid measures to consider when treating an open wound - NSC Mechanical Technology Fitting and Machining - Question 2 - 2021 - Paper 1
Step 1
Explain TWO first-aid measures to consider when treating an open wound.
96%
114 rated
Only available for registered users.
Sign up now to view full answer, or log in if you already have an account!
Answer
Use surgical gloves to prevent infection and ensure cleanliness while treating the wound.
Avoid removing anything that is stuck to the wound to prevent further injury and bleeding.
Step 2
State TWO safety precautions that must be adhered to after the surface grinder has been switched on.
99%
104 rated
Only available for registered users.
Sign up now to view full answer, or log in if you already have an account!
Answer
Never leave the grinder unattended to ensure continuous supervision and safety.
Do not put hands near the workpiece while the grinder is in motion to prevent potential injuries.
Step 3
Give ONE reason why the pressure gauge of a hydraulic press must be calibrated frequently.
96%
101 rated
Only available for registered users.
Sign up now to view full answer, or log in if you already have an account!
Answer
To ensure accurate readings, which is crucial for the safe and effective operation of the hydraulic press.
Step 4
Which TWO hazards are prevented by the finger protectors fitted to power-driven guillotines?
98%
120 rated
Only available for registered users.
Sign up now to view full answer, or log in if you already have an account!
Answer
The finger protectors prevent the hazards of getting the fingers cut by the blades.
They help prevent the fingers from being crushed by the hold-downs.
Step 5
State TWO safety measures to be considered before gas or flame cutting operations can be performed.
97%
117 rated
Only available for registered users.
Sign up now to view full answer, or log in if you already have an account!
Answer
Ensure that the work area is effectively partitioned off to prevent accidental injuries.
All equipment must be in safe working condition to avoid any hazards during operations.
Step 6
Which type of workshop layout is shown in FIGURE 2.6 below?
97%
121 rated
Only available for registered users.
Sign up now to view full answer, or log in if you already have an account!
Answer
The workshop layout shown in FIGURE 2.6 is identified as a product layout.
